The V12 engine was bored out to 4,942 cc (from 4,823) with a corresponding 8% increase in power (to 340 bhp) and a 9.5% increase in torque for a 0-62 mph time of 6.7 seconds, and a standing quarter mile of 14.6 seconds compared to 14.8 for the 400i. The 412 was also the first Ferrari to offer Bosch ABS as standard.
In the Spring of 1985 the final evolution of the Pininfarina designed 2+2 series, that had started with the 365 GT4 2+2 in 1973, was introduced, with the presentation of the 412 model at the Geneva Salon. The 412 model designation referred to the swept volume of a single cylinder, thus the V12 engine had been increased in size to 4943cc, by providing a 1mm larger diameter bore of 82mm allied to the same 78mm stroke, producing a claimed 340 bhp at 6000rpm.
As with the preceding 400i series cars it was fitted with fuel injection, and was available either with a five speed manual gearbox or a three speed automatic transmission. However, on this model there was no external badging to denote that a car was automatic, the tail badge stated simply 412, whichever gearbox was fitted. The engine type reference numbers were to F 101 E 070 and 010, with chassis type numbers F 101 EL 170 and 110, for the automatic and manual examples respectively.
At a glance it appeared very similar to a 400 series car, but closer inspection revealed a different road wheel design, that covered an ABS braking system as standard, the first roadgoing Ferrari so equipped. Apart from this the mechanical layout and elements were very similar to its predecessors. Viewing the body more closely showed a revised rear wing line providing a less pronounced slope to the tail, with a raising of the boot lid line, which had the benefit of increasing the luggage capacity.
The bumpers of the 412 were body colour coded, and the door mirror design was a larger more rectangular profile than that of the last 400i models, without the small enamel Ferrari shield. Internally the seat design altered, along with the control layout on the centre console. Like the 365 GT4 2+2, and the 400 series, right or left hand drive power assisted steering was available, and again there was no USA market version. Similarly, the bodies were constructed at the Pininfarina factory in Turin, with the fully trimmed shells shipped to Ferrari for fitment of the mechanical components.